Dacor RNF241WCL Installation Instructions Single Zone Model - Page 5

Getting to Know Your Wine Cellar Features The right environment for your wines... A vine is an extremely sensitive plant. Grape quality is dependent on three factors: light, air humidity and ambient temperature. This sensitivity continues even after the wine is bottled. To allow a wine's flavor to fully develop and to preserve the excellent aroma, it has to be properly stored. Your wine cellar offers the best storage environment: ™™ A wide temperature range: The unit has a wide temperature adjustment range. It allows you to store wine at low temperature for superb aging or at a higher temperature for serving wine lightly chilled. The temperature can be set between 41 to 72°F (5 to 22°C). ™™ High storage capacity: High storage capacity allows you to preserve the flavor of your favorite wines. Your wine cellar can store up to 46 bottles of wine (750 mL each). ™™ Low Vibration Cooling System and Storage: Wines require a tranquil environment. The latest technology of your wine cellar provides virtually vibration free cooling, helping to preserve wine taste. In addition, the sliding beech wood storage shelves also provide additional vibration absorption. Additional Features • Automatic defrosting system • Soft white LED interior lighting with on/off switch • Open-door and malfunction warning system • Double-layer, UV resistant, tempered glass door, shields wines from UV rays harmful to wine. • Door lock Model RNF241WCL: Hinges on left, handle on right Model RNF241WCR: Hinges on right, handle on left Racks/Shelves (see diagram above)  Wood slide-out racks: Hold up to eight bottles of wine each  Bottom shelf: Holds up to six bottles of wine Operating Your Wine Cellar   °C   IMPORTANT: This unit has a compressor reset delay circuit designed to protect the compressor when it is warm. If the unit °F will not start, disconnect the power cord for 5 minutes, then reconnect. The Control Panel  ON/OFF key  LIGHT key  Temperature display  Temperature UP key  Temperature DOWN key Turning the Power ON and OFF • Clean your appliance before turning it on for the first time. See the Care and Cleaning section. • Connect the power cord to the electrical outlet. The unit will come on. ON/OFF key • To turn the unit off, touch and hold the ON/OFF key for about five seconds. The display will turn off to indicate that the appliance is off. • To turn it on, touch the ON/OFF key until the display lights up. Setting the Temperature °C • Touch the UP or DOWN key repeatedly to raise or lower the temperature. You can change the settings in °F increments of 1°F (or 1°C). The temperature setting will flash on the display while you change it. • After five seconds the display will stop °C flashing and the actual temperature of the compartment will be displayed. °F NOTE: Depending on the amount of temperature change, it may take a few minutes to a few hours for the compartment temperature to reach the newly adjusted temperature level. UP Key DOWN key Changing the temperature scale (ºF or ºC) You can select the temperature scale that the unit uses to display the temperature settings: • Touch and hold the LIGHT key for about five seconds. The temperature scale indicator light on the right side of the display will change to indicate the new temperature scale. Touch and hold the LIGHT key again to change back. LIGHT Key 3 °C °F