Dacor RNR30N Installation Instruction - Renaissance 30" Electric Inductio - Page 19

Installation Instructions Re-installing the Oven Door WARNING To avoid personal injury or damage to the door from it falling off its hinges: • Make sure that the notch on the bottom of each hinge rests on top of the lower lip of each hinge receptacle before attempting to open the oven door. • Rotate the hinge locks toward the front of the range immediately after installation of the door. 1. Grasp the oven door on opposite sides and hold it at a 15° angle from the front of the range. Slide the hinges into the hinge openings, resting the bottom of the hinge arms on the hinge receptacles. Continue to hold the door at a 15° angle with one hand while pushing in on each of the bottom corners of the door. Push until the notch on the bottom of each hinge slips over the lower lip of each hinge receptacle. Verifying Proper Operation 1. Remove any packaging from inside the oven. 2. Slide the oven racks onto the supports inside the oven chamber according to the use and care manual. 3. Prior to operating the range, read the accompanying use and care manual carefully. Important safety, service and warranty information are contained within. 4. Turn on power to the range at the circuit breaker panel or fuse box. 5. Set the clock according to the use and care manual. 6. Press the BAKE key on the control panel. The default bake temperature should appear on the display. 7. Press START. After approximately three (3) minutes, check to make sure the oven is heating. 8. Press CANCEL SECURE. 9. Place a pot 1/4 full with water on one of the cooking elements. Match the size of the pot to the size of the cooking element. NOTE: You must use a pot that attracts a magnet on the pan bottom to test operation. 10. Hold your finger on the ON/OFF key of the corresponding control for one second to activate. The power light should come. Power Down key light Up key ON/OFF key Heat indicator Power level indicators 2. Lower the door to the fully opened position. 3. Rotate the two hinge locks toward the range. 4. Slowly and carefully open and close the door completely to ensure that it is properly installed. No pan detected light Power boost light Cooktop Control 11. Touch the power level up key (►) repeatedly. Verify that the power level goes up. 12. Touch down (◄) repeatedly. Verify that the power level goes down. 13. Touch the power level up key (►) repeatedly until the power boost light comes on. 14. Once the pot begins to heat, verify that the heat indicator light comes on. 15. Touch ON/OFF to turn off the element. 16. Repeat steps 9 through 15 for the remaining elements. continued... 17