Dacor SGM365 Installation Instructions - Page 12
Verifying Proper Operation Cont, Installation Checklist - repair
View all Dacor SGM365 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Installation Instructions Verifying Proper Operation (Cont) Installation Checklist • Once the burner lights, rotate the control knob counterclockwise from HIGH to LOW to adjust the flame height progressively. • When the unit is installed properly, the flame will be steady. It will also have a sharp, blue inner cone that will vary in length proportional to the burner size. The flame will be reduced by the Smart Flame™ feature under the grate fingers to increase grate life. Normal Flame Appearance NOTE: If the cooktop does not operate properly, follow these troubleshooting steps: • Verify that power and gas are supplied to the cooktop. • Check to make sure that the power plug is connected to the electrical outlet and that power is turned on at the circuit breaker or fuse box. • Check to make sure that the burners are properly seated. • If the burner continues to spark after ignition without stopping, have a licensed electrician check the electrical outlet for proper grounding or reversed polarity. • Repeat the above burner ignition test. • If the appliance still does not work, contact Dacor Distinctive Service at (877) 337-3226. Do not attempt to repair the appliance yourself. If you need service, be sure to have the model and serial numbers available when you call. See inside cover for location. Dacor is not responsible for the cost of correcting problems caused by a faulty installation. warning To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the homeowner. The importance of proper installation of your Dacor cooktop cannot be overemphasized. □□ Is the electrical outlet for the cooktop grounded and located according to these instructions and in accordance with all applicable electrical codes? See page 4. □□ Is the gas service for the cooktop located and installed according to these instructions and in accordance with all applicable codes? See page 4. □□ Has the gas supply inlet pressure been measured to ensure that it does not exceed the maximums stated in these instructions? See page 4. □□ Is the cooktop secured using the provided hold-down brackets? See page 8. □□ Is the cooktop connected to the gas supply according to these instructions and in accordance with all applicable codes? Did the installer check the gas supply for leaks? See page 8. □□ Are the burners and grates properly installed according to these instructions? See page 9. □□ Has proper operation been verified? □□ Has the warranty been activated on-line or the warranty card filled out completely and mailed? 10