DeLonghi TCH6590ER Owner Manual - Page 4

ELECTRICAL CONNECTION Before plugging the appliance into the mains socket, check that the mains power supply corresponds to the value indicated on the rating plate. Installation The appliance can be used on any rigid horizontal surface. OPERATION AND USE 1. Plug the appliance into an appropriate outlet. 2. The appliance will emit a "beep" and the ON light will come on. It will remain lit as long as there is power to the appliance. 3. Press button (G) to turn the appliance on. 4. The appliance starts up in LOW mode (minimum heat output). The display shows the current room temperature. 5. Press the MODE button (F) to switch to HIGH mode (maximum heat output). The display shows the current room temperature. 6. Press the MODE button (F) again to switch the appliance to AUTO mode. The display shows the temperature set point. Use the + and - buttons to set a different tem- perature. After a few seconds, room temperature is shown on the display. 7. Press the MODE button (F) again to switch the appliance back to LOW mode. When the MODE button is pressed continuously, the appliance switches through the fol- lowing modes in sequence: LOW HIGH AUTO. 8. To turn the appliance off, hold button (G) down for a few seconds. MOTORIZED ROTATING BASE The appliance has a motorized rotating base to distribute the air flow over a larger area. To activate the motorized base press the swing switch (C). The appliance swings from right to left. To stop the appliance in the desired position, simply press button (C). To turn the appliance off, hold button (G) down for a few seconds. Adjusting the thermostat 1. Press the MODE button (F) until AUTO is displayed. 2. Use the + and - buttons to increase or reduce the temperature set point. The thermostat will automatically maintain the temperature set and keep it constant. 3. When room temperature is 2°C above the set temperature, the appliance goes off. The internal fan will stop after 15 seconds. 4. When room temperature drops below the set temperature, the appliance comes on automa- tically. Note: if swing mode is active, press buttons to change the set temperature, the swinging of the base will stop to allow a new temperature to be set. After the setting procedure has been completed, the swinging of the base will resume automatically. Timer function This function can be activated during any operating mode. The timer can be used to program the time the appliance remains in operation, from 1 to 8 hours. Each time you press the button (F), the operating time increases by one hour. When the timer has been set, the time decreases in steps of one hour and the time remaining is displayed. At the end of the set time the appliance goes off. If you do not want to use the appliance with the timer, press the button (F) again to return to manual operation. The words "8 h" will be displayed. Note: The display shows room temperature in either °C or °F. To select, press the + and - buttons together for a few seconds, then release. 4