Dell 3100MP Content: Dell 3100MP Projector User's Guide - Page 12

Changing the Lamp, CAUTION, Lamp Changing Procedure, Reset, Back to Contents - projector lamp

Get Dell 3100MP PDF manuals and user guides View all Dell 3100MP manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

Changing the Lamp Replace the lamp when you see the Lamp may fail soon! Replacement suggested! message on the screen by carefully following these instructions. CAUTION: The lamp becomes very hot with use. Do not attempt to replace the lamp after use until the projector has been allowed to cool down for at least 30 minutes. Lamp Changing Procedure: 1. Turn off the projector and disconnect the power cord. 2. Let the projector cool for at least 30 minutes. 3. Remove the two screws that secure the lamp cover, and remove the cover. 4. Remove the three screws that secure the lamp. 5. Pull up the lamp by its metal handle. 6. Reverse steps 1 through 5 to install the new lamp. 7. Reset the lamp by selecting the left Lamp Reset icon in the OSD Management tab. 8. Dell may require that lamps replaced under warranty are returned to Dell. Otherwise, contact your local waste disposal agency for the address of the nearest deposit site CAUTION: Do not touch the bulb or the lamp glass at any time. The bulb may explode due to improper handling, including the touching of the bulb or the lamp glass. Back to Contents Page

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
Changing the Lamp
Replace the lamp when you see the
Lamp may fail soon! Replacement suggested!
message
on the screen by carefully following these instructions.
CAUTION:
The lamp becomes very hot with use. Do not attempt to replace the lamp after use until the
projector has been allowed to cool down for at least 30 minutes.
Lamp Changing Procedure:
1. Turn off the projector and disconnect the
power cord.
2. Let the projector cool for at least 30
minutes.
3. Remove the two screws that secure the
lamp cover, and remove the cover.
4. Remove the three screws that secure the
lamp.
5. Pull up the lamp by its metal handle.
6. Reverse steps 1 through 5 to install the
new lamp.
7. Reset the lamp by selecting the left
Lamp
Reset
icon in the OSD
Management
tab.
8. Dell may require that lamps replaced under
warranty are returned to Dell. Otherwise,
contact your local waste disposal agency for
the address of the nearest deposit site
CAUTION:
Do not touch the bulb or the lamp glass at any time. The bulb may explode due to improper
handling, including the touching of the bulb or the lamp glass.
Back to Contents Page