Dell Alienware 27 Gaming AW2720HF Alienware AW2720HF Monitor Users Guide - Page 29
Removing the monitor stand, Universal Serial Bus USB specific problems
![]() |
View all Dell Alienware 27 Gaming AW2720HF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
2. Connect the other end of the USB 3.0 upstream cable to an appropriate USB 3.0 port on your computer. 3. Connect the USB 3.0 peripherals to the USB 3.0 downstream ports on the monitor. 4. Plug the power cables for your computer and monitor into a wall outlet. 5. Turn on the monitor and the computer. If your monitor displays an image, installation is complete. If it does not display an image, see Universal Serial Bus (USB) specific problems. Removing the monitor stand NOTE: To prevent scratches on the display when removing the stand, ensure that the monitor is placed on a soft, clean surface. NOTE: The following instructions are applicable only for attaching the stand that was shipped with your monitor. If you are attaching a stand that you purchased from any other source, follow the set up instructions that were included with the stand. To remove the stand: 1. Turn off the monitor. 2. Disconnect the cables from the computer. 3. Place the monitor on a soft cloth or cushion. 4. Carefully slide and remove the I/O cover from the monitor. Setting up the monitor | 29
![](/manual_guide/products/dell-alienware-27-gaming-aw2720hf-alienware-aw2720hf-monitor-users-guide-b64ffb9/29.png)