Dell Brocade M5424 Brocade 7.1.0 Fabric OS Command Reference Guide - Page 36

2 aaaConfig OPERANDS The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This command has the following operands: server Specifies an IP address or a server name in dot-decimal notation. IPv6 addresses are supported. If a name is used, a DNS entry must be correctly configured for the server. If the specified server IP address or name already exists in the current configuration, the command fails and generates an error. However, the command does not validate the server name against the IP address in the configuration. Make sure to avoid duplicate configuration of the same server, one specified by the name, the other specified by the IP address. --show Displays the current AAA service configuration. --add | --change server [options] Adds or modifies a RADIUS, LDAP, or TACACS+ server. The --add option appends the specified server to the end of the current configuration list. A maximum of 5 servers are supported for each authentication type. The --change option modifies the specified server configuration to use the new arguments. The server must be one of the IP addresses or names shown in the current configuration. The following options are supported: -conf radius | ldap | tacacs+ Specifies the server configuration as either RADIUS, LDAP, or TACACS+. This operand is required. The following operands are optional: -p port Specifies the RADIUS, LDAP, or TACACS+ server port number. Supported range is 1 to 65535. The default port is 1812 for RADIUS authentication. The default port is 389 for LDAP authentication. The default port is 49 for TACACS+ authentication. This operand is optional. If no port is specified, the default is used. -t timeout Specifies the response timeout for the RADIUS, the LDAP or the TACACS+ server. The supported range is 1 to 30 seconds. The default is 3 seconds. This operand is optional. If no timeout is specified, the default is used. -d domain Specifies the Windows domain name for the LDAP server, for example, brocade.com. This option is valid only with the -conf ldap option. This operand is required. -s secret Specifies a common secret between the switch and the RADIUS or TACACS+ server. The secret must be between 8 and 40 characters long. This option is valid only with -conf radius or -conf tacacs+options, and it is optional. The default value is sharedsecret. -a Specifies the remote authentication protocol for the RADIUS or TACACS+ server. This operand is valid with -conf radius or -conf tacacs+ options, and it is optional. The default value for this operand is CHAP. 8 Fabric OS Command Reference 53-1002746-01