Dell Brocade M5424 Brocade 7.1.0 Fabric OS Troubleshooting and Diagnostics Gui - Page 110
Topology 3: Access Gateways,
View all Dell Brocade M5424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
10 Diagnostic Port (D_Port) FIGURE 5 ICLs connecting chassis blades For configuration details see "Using D_Port without HBAs" on page 95. Topology 3: Access Gateways Figure 6 illustrates a switch configured as a single Access Gateway connected to a fabric switch. N and F represent, respectively, an N_Port and an F_Port to be configured as D_Ports. (See note below.) The following equipment is supported, in any mix-or-match combination: • Access Gateways: Brocade 6505, 6510 • Switches: Brocade DCX 8510-4, DCX 8510-8, 6505, 6510, 6520 FIGURE 6 Single Access Gateway to switch Figure 7 illustrates multiple Access Gateways connected to a switch in a cascaded topology. N and F represent, respectively, an N_Port and an F_Port to be configured as D_Ports. (See note below.) There is no D_Port support for HBA connectivity to the Access Gateway. The following equipment is supported, in any mix-or-match combination: • Access Gateways: Brocade 6505, 6510 • Switches: Brocade DCX 8510-4, DCX 8510-8, 6505, 6510, 6520 FIGURE 7 Multiple Access Gateways cascaded to switch For configuration details see "Using D_Port without HBAs" on page 95. NOTE You cannot configure a D_Port in the above topologies if N_Port-to-F_Port mappings are already present on the Access Gateway. See"Saving port mappings on an Access Gateway" on page 97. 94 Fabric OS Troubleshooting and Diagnostics Guide 53-1002751-01