Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 701

show ip dhcp snooping Display the contents of the DHCP binding table or display the interfaces configured with IP Source Guard. C9000 Series Syntax Parameters show ip dhcp snooping [binding | source-address-validation [discard-counter | interface interface]] binding Display the interfaces configured with IP Source Guard. source-addressvalidation Display the interfaces configured with IP Source Guard. discard-counter Display the drop count of the packets. interface interface Enter the keyword interface then type one of the following interface types and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet. • For a 10-Gigabit Ethernet interface, enter the keyword tengigabitethernet. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE. • For a Port Channel interface, enter the keyword port-channel then a number. Range is from 1 to 4096. • For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigabitEthernet then the pe-id, stack-unit unit number, and port-id. The pe-id range is 0-255; the stack unit number range is 0-7; and the port- ID range is 0 -47. Defaults Command Modes none • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.3.1.0 7.8.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series. Introduced on the C-Series and S-Series. Dynamic Host Configuration Protocol (DHCP) 701