Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 640

• Is the OSPF process active on the interface? • Are adjacencies established correctly? • Are the interfaces configured for Layer 3 correctly? • Is the router in the correct area type? • Have the routes been included in the OSPF database? • Have the OSPF routes been included in the routing table (not just the OSPF database)? Some useful troubleshooting commands are: • show interfaces • show protocols • debug IP OSPF events and/or packets • show neighbors • show routes To help troubleshoot OSPFv2, use the following commands. • View the summary of all OSPF process IDs enables on the router. EXEC Privilege mode show running-config ospf • View the summary information of the IP routes. EXEC Privilege mode show ip route summary • View the summary information for the OSPF database. EXEC Privilege mode show ip ospf database • View the configuration of OSPF neighbors connected to the local router. EXEC Privilege mode show ip ospf neighbor • View the LSAs currently in the queue. EXEC Privilege mode show ip ospf timers rate-limit • View debug messages. EXEC Privilege mode debug ip ospf process-id [event | packet | spf | database-timers rate-limit] To view debug messages for a specific OSPF process ID, use the debug ip ospf process-id command. If you do not enter a process ID, the command applies to the first OSPF process. To view debug messages for a specific operation, enter one of the optional keywords: - event: view OSPF event messages. - packet: view OSPF packet information. - spf: view SPF information. - database-timers rate-limit: view the LSAs currently in the queue. Example of Viewing OSPF Configuration Dell#show run ospf ! router ospf 3 Open Shortest Path First (OSPFv2 and OSPFv3) 640