Dell DR6000 NetVault - Setting Up the DR Series System as an RDA or VTL Backup - Page 21
Configuring the iSCSI target – Linux
View all Dell DR6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
3.1.3 Configuring the iSCSI target - Linux Before you begin this procedure, ensure that the iSCSI initiator is installed (iscsi-initiator-utils). For example: yum install iscsi-initiator-utils ; /etc/init.d/iscsi start To configure the iSCSI target for Linux, follow these steps. 1. Add the CHAP Authentication details for the DR Series system on the Linux Initiator as follows: a. Edit /etc/iscsi/iscsid.conf and un-comment the following line: node.session.auth.authmethod = CHAP b. Modify the following lines: # To set a CHAP username and password for initiator # authentication by the target(s), uncomment the following lines: node.session.auth.username = iscsi_user node.session.auth.password = St0r@ge!iscsi 2. Set the Discovery Target Node(s) by using this command: iscsiadm -m discovery -t st -p For example: iscsiadm -m discovery -t st -p 10.8.230.108 3. Enable logon to the DR Series system iSCSI VTL target(s) by using the following command: iscsiadm -m node --portal --login 22 Setting Up the Dell DR Series System as an RDA or VTL Backup Target for Dell NetVault Backup