Dell EqualLogic PS4210XS Updating Firmware for EqualLogic PS Series Storage Ar - Page 10
PS Series Arrays – Planning and Prerequisites, PS Group Health Check, Dell EqualLogic PS Series
![]() |
View all Dell EqualLogic PS4210XS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
3 PS Series Arrays - Planning and Prerequisites NOTE: Any account with group administrator permissions can update array firmware. Before performing a firmware update: • You must understand the impact of the update on the infrastructure and plan the update process carefully to avoid unplanned downtime. After updating any SAN component, test it to make sure that it is functioning properly. NOTE: Dell recommends that you perform firmware updates during periods of low activity. If possible, perform the update after a backup. • If you are planning to update the firmware on your FS Series appliances, you must first update the firmware on your PS Series storage arrays. • Visit the Dell Recommended firmware versions page at eqlsupport.dell.com for the latest release recommendations. If the array is not running a supported version of array firmware, Dell strongly recommends that you update the firmware. • If you receive an array with a later version of firmware than the version that is running on other arrays, update all your arrays to the later firmware version. If that update is not feasible, contact your Dell EqualLogic support representative. • If you are adding an array to an existing group, update the firmware on the other group members to the latest recommended firmware first. Then, update the array's firmware to the latest recommended version. When all group members are running the same firmware, add the new member to the group. NOTE: Mixed firmware groups are supported only during the update process. • Optimize your SAN for high availability by reading and implementing the best practices documented in Dell EqualLogic PS Series Storage Arrays iSCSI Initiator and Operating System Considerations: Optimizing Your SAN Environment for High Availability. PS Group Health Check Make sure that the EqualLogic PS Series group and arrays that you are updating have no current health problems. Check the following areas for issues: • Group Message Log - Verify that no active errors or warnings are in the group message log. • Group Configuration Check - Verify that RAID is healthy and not in a degraded state. • Individual array attributes - Verify that disk drives are healthy and no disks have failed. - Verify that no arrays exhibit any enclosure threshold warnings. - Verify that array controllers are healthy and update paths are allowed. Do not update a PS Series group or upgrade an array if the array is experiencing any of the following issues: • Near or above max I/O load - View SAN HQ to determine this value. • Limited free space - Recommended minimum free space per pool is 5 percent of total pool capacity or 100GB per pool member, whichever is less. View SAN HQ to determine this value. • A replication operation is in progress. • A volume or array migration is in progress. 10 PS Series Arrays - Planning and Prerequisites
![](/manual_guide/products/dell-equallogic-ps4210-updating-firmware-equallogic-ps-series-storage-arrays-fs-series-appliances-4251e75/10.png)