Dell Force10 C150 FTOS Configuration Guide FTOS 8.4.2.7 E-Series TeraScale, C- - Page 793

You can augment the default prioritization using the command [no] power inline priority {critical | high | low}, where critical is the highest priority, and low is the lowest. FTOS ignores any LLDP-MED priority on this port if you configure a priority with this command. If you do not configure a port priority with this command, FTOS honors any LLDP-MED priority. In general, priority is assigned in this order: 1. power inline [static | auto] setting: power inline static ports have a higher priority than power inline auto ports 2. power inline priority {critical | high | low} setting or LLDP-MED TLV, if power inline priority is not configured 3. slot ID 4. port ID Recover from a Failed Power Supply If ports are PoE-enabled, and a PSU fails, power might be terminated on some ports to compensate for the power loss. This does not affect PoE individual port configurations. For C-Series, use the show power supply command to display PSU status (Figure 36-4). For S-Series, see the Power over Ethernet (PoE) chapter in the FTOS Command Reference for the S-Series for an example of the output of the show power inline output and its field descriptions. Figure 36-4. show power supply Command Example R1#show power supply Power Model Supply Number Type Status PS0 -- -- Absent PS1 CC-C300-PWR-AC AC Active PS2 CC-C300-PWR-AC AC Fail PS3 CC-C300-PWR-AC AC Remote Off PS4 -- -- Absent PS5 -- -- Absent PS6 -- -- Absent PS7 -- -- Absent If power must be terminated for some ports, the order in which ports are affected is based on priority. Ports with the lowest priority are terminated first (see Manage Power Priorities on page 792). Power over Ethernet | 793