Dell Force10 C300 FTOS Configuration Guide FTOS 8.4.2.7 E-Series TeraScale, C- - Page 936

www.dell.com | support.dell.com FTOS supports both inbound and outbound SSH sessions using IPv4 or IPv6 addressing. Inbound SSH supports accessing the system through the management interface as well as through a physical Layer 3 interface. For details on command syntax, see the Security chapter in the FTOS Command Line Interface Reference. SCP is a remote file copy program that works with SSH and is supported by FTOS. Note: The Windows-based WinSCP client software is not supported for secure copying between a PC and an FTOS-based system. Unix-based SCP client software is supported. To use the SSH client, use the following command in the EXEC Privilege mode: Command Syntax Command Mode ssh {hostname | hostip} [-l username | -p port-number | -v {1 | 2} EXEC Privilege Purpose Open an SSH connection specifying the hostname or hostip, username, port number, and version of the SSH client. hostip is the IP address of the remote device, which can be an IPv4 address (A.B.C.D)or IPv6 address (X:X:X:X::X). To enable the SSH server for version 1 and 2, use the following command in the CONFIGURATION mode: Command Syntax ip ssh server {enable | port port-number} Command Mode CONFIGURATION Purpose Configure the Dell Force10 system as an SCP/SSH server. To enable the SSH server for version 1 or 2 only, use the following command: Command Syntax ip ssh server version {1|2} Command Mode CONFIGURATION Purpose Configure the Dell Force10 system as an SSH server that uses only version 1 or 2. To view the SSH configuration, use the following command in EXEC Privilege mode: Command Syntax show ip ssh Command Mode Purpose EXEC Privilege Display SSH connection information. Figure 45-6 on page 937 shows the use of the command ip ssh server version 2 to enable SSH version 2, and the show ip ssh command to confirm the setting. 936 | Security