Dell Force10 S60-44T Installing the S60 System - Page 37

To access the USB-B console port, follow these steps, Technical Support.

Get Dell Force10 S60-44T PDF manuals and user guides View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals

Page 37 highlights

To access the USB-B console port, follow these steps: Step Task 1 Power on the PC (Dell Force 10 recommends using an XP operating system). 2 Connect the USB-A end of cable (included) into an available USB port on the PC. 3 Connect the USB-B end of cable into the USB-B console port on the S60 system. 4 Power on the S60 system. 5 Install the necessary USB device drivers (an internet connection is required). For assistance, contact Dell Force10 Technical Support. 6 Open your terminal software emulation program to access the S60 system. 7 Set the terminal connection settings as follows: • 9600 baud rate • No parity • 8 data bits • 1 stop bit • No flow control 8 The CLI command prompt appears when you are connected to the S60 system. Access the Console Ports | 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
Access the Console Ports
|
37
To access the USB-B console port, follow these steps:
Step
Task
1
Power on the PC (Dell Force 10 recommends using an XP operating system).
2
Connect the USB-A end of cable (included) into an available USB port on the PC.
3
Connect the USB-B end of cable into the USB-B console port on the S60 system.
4
Power on the S60 system.
5
Install the necessary USB device drivers (an internet connection is required). For assistance, contact Dell Force10
Technical Support.
6
Open your terminal software emulation program to access the S60 system.
7
Set the terminal connection settings as follows:
•
9600 baud rate
•
No parity
•
8 data bits
•
1 stop bit
•
No flow control
8
The CLI command prompt appears when you are connected to the S60 system.