Dell M4400 Setup and Quick Reference Guide - Page 41
S.M.A.R.T error - bios
View all Dell M4400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
ALERT! PREVIOUS ATTEMPTS AT BOOTING THIS SYSTEM HAVE FAILED AT CHECKPOINT [NNNN]. FOR HELP IN RESOLVING THIS PROBLEM, PLEASE NOTE THIS C H E C K P O I N T A N D C O N T A C T D E L L TE C H N I C A L S U P P O R T - The computer failed to complete the start routine three consecutive times for the same error (see "Contacting Dell" on page 65 for assistance). CMOS CHECKSUM ERROR - Possible motherboard failure or RTC battery low. Replace battery. See your Service Manual at support.dell.com or see "Contacting Dell" on page 65 for assistance. CPU FAN FAILURE - Processor fan failure. Replace processor fan. See your Service Manual at support.dell.com. HA R D -DISK DRIVE FAILURE - Possible hard drive failure during hard drive POST. Check cables, swap hard disks, or see "Contacting Dell" on page 65 for assistance. HA R D -D I S K D R I V E R E A D F A I L U R E - Possible hard drive failure during harddrive start test (see "Contacting Dell" on page 65 for assistance). KEYBOARD FAILURE - Keyboard failure or keyboard cable loose. N O B O O T D E V I C E AVAILABLE - No bootable partition on hard drive, or the hard drive cable is loose, or no bootable device exists. • If the hard drive is your boot device, ensure that the cables are connected and that the drive is installed properly and partitioned as a boot device. • Enter system setup and ensure that the boot sequence information is correct see your Service Manual at support.dell.com). N O T I M E R T I C K I N T E R R U P T - A chip on the system board might be malfunctioning or motherboard failure (see "Contacting Dell" on page 65 for assistance). USB OVER CURRENT ERROR - Disconnect the USB device. Use external power source for the USB device. NOTICE - HARD DRIVE SELF MONITORING SYSTEM HAS REPORTED THAT A PARAMETER HAS EXCEEDED ITS NORMAL OPERATING RANGE. DELL RECOMMENDS THAT YOU BACK UP YOUR DATA REGULARLY. A PARAMETER OUT OF RANGE MAY OR M A Y N O T I N D I C A T E A P O T E N T I A L H A R D D R I V E P R O B L E M - S.M.A.R.T error, possible hard drive failure. This feature can be enabled or disabled in BIOS setup. Troubleshooting 41