Dell N5694 User Guide - Page 22

Terminating the SCSI Bus,

Get Dell N5694 - PERC 320 RAID Controller PDF manuals and user guides View all Dell N5694 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

Step 2. Plug the 68-pin connector on the other end of the internal SCSI ribbon cable into the SCSI connector on the internal SCSI device, as Figure 2.9 shows. Figure 2.9 Connecting Multiple Internal SCSI Devices . Step 3. If you have another internal SCSI device, connect the internal SCSI ribbon cable to it, as Figure 2.9 shows. You can connect other devices if the cable has more connectors. The Ultra320 SCSI host adapters support up to 15 SCSI devices connected to each SCSI channel. Step 4. Be sure that termination is enabled at the end of the cable that is farthest away from the SCSI host adapter. Refer to Section 2.4, "Terminating the SCSI Bus," on page 2-12 for details on SCSI bus termination. 2-8 Detailed Host Adapter Installation Version 2.2 Copyright © 2002-2004 by LSI Logic Corporation. All rights reserved.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
2-8
Detailed Host Adapter Installation
Version 2.2
Copyright © 2002–2004 by LSI Logic Corporation. All rights reserved.
Step 2.
Plug the 68-pin connector on the other end of the internal SCSI
ribbon cable into the SCSI connector on the internal SCSI
device, as
Figure 2.9
shows.
Figure 2.9
Connecting Multiple Internal SCSI Devices
Step 3.
If you have another internal SCSI device, connect the internal
SCSI ribbon cable to it, as
Figure 2.9
shows. You can connect
other devices if the cable has more connectors. The Ultra320
SCSI host adapters support up to 15 SCSI devices connected
to each SCSI channel.
Step 4.
Be sure that termination is enabled at the end of the cable that
is farthest away from the SCSI host adapter. Refer to
Section 2.4, “Terminating the SCSI Bus,” on page 2-12
for
details on SCSI bus termination.
.