Dell OptiPlex 5070 Tower Setup and Specifications - Page 26
Post behavior, Manageability, Table 24. Power Management, continued, Table 25. POST Behavior
![]() |
View all Dell OptiPlex 5070 Tower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Table 24. Power Management (continued) Option Description Wake on LAN/WWAN This option allows the computer to power up from the off state when triggered by a special LAN signal. This feature only works when the computer is connected to AC power supply. ● Disabled - Does not allows the system to power on by special LAN signals when it receives a wake-up signal from the LAN or wireless LAN. ● LAN or WLAN - Allows the system to be powered on by special LAN or wireless LAN signals. ● LAN Only - Allows the system to be powered on by special LAN signals. ● LAN with PXE Boot - A wakeup packet sent to the system in either the S4 or S5 state, that will cause the system to wake-up and immediately boot to PXE. ● WLAN Only - Allows the system to be powered on by special WLAN signals. This option is Disabled by default. Block Sleep Allows you to block entering to sleep (S3 state) in OS environment. This option is disabled by default. Post behavior Table 25. POST Behavior Option Numlock LED Keyboard Errors Fast Boot Extend BIOS POST Time Full Screen Logo Warnings and Errors Description Allows you to enable or disable the Numlock feature when your computer starts. This option is enabled by default. Allows you to enable or disable the keyboard error reporting when the computer starts. The option Enable Keyboard Error Detection is enabled by default. This option can speed up the boot process by bypassing some compatibility steps: ● Minimal - The system boots quickly, unless the BIOS has been updated, memory changed, or the previous POST did not complete. ● Thorough - The system does not skip any steps in the boot process. ● Auto - This allows the operating system to control this setting (this works only when the operating system supports Simple Boot Flag). This option is set to Thorough by default. This option creates an additional pre-boot delay. ● 0 seconds (default) ● 5 seconds ● 10 seconds This option will display full screen logo if your image match screen resolution. The option Enable Full Screen Logo is not set by default. This option causes the boot process to only pause when warning or errors are detected. Choose any one of the option: ● Prompt on Warnings and Errors ● Continue on Warnings ● Continue on Warnings and Errors Manageability Table 26. Manageability Option USB provision MEBx Hotkey Description This option is not selected by default. This option is selected by default. 26 System setup
![](/manual_guide/products/dell-optiplex-5070-tower-setup-specifications-e7b152f/26.png)