Dell OptiPlex XE Dell™ OptiPlex™ XE - Broadcom® T
Dell OptiPlex XE Manual
 |
View all Dell OptiPlex XE manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell OptiPlex XE manual content summary:
- Dell OptiPlex XE | Dell™ OptiPlex™ XE - Broadcom® T - Page 1
identify and monitor the hardware and thermal failures on your Dell OptiPlex XE from a remote, centralized location. You can monitor the status of your computer through the Dell Client Manager (DCM) version 3.0 or higher. TruManage is pre-installed on your computer. However, you need to enable and - Dell OptiPlex XE | Dell™ OptiPlex™ XE - Broadcom® T - Page 2
and Thermal Failures TruManage will notify you if the fan speed or the temperature is at abnormal levels. Fans monitored: • Processor Fan • Hard drive Fan • Power Supply Unit Fan Temperatures monitored: • Processor Temperature • System Ambient Temperature • Power Supply Unit Temperature - Dell OptiPlex XE | Dell™ OptiPlex™ XE - Broadcom® T - Page 3
. Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell, the Dell logo, and OptiPlex are trademarks of Dell Inc.; Broadcom and TruManage are the trademarks of Broadcom Corporation and/or its - Dell OptiPlex XE | Dell™ OptiPlex™ XE - Broadcom® T - Page 4
-
1 -
2 -
3 -
4
 |
 |
Dell™ OptiPlex™ XE —
Broadcom
®
TruManage™
Broadcom TruManage allows you to automate common tasks and identify and
monitor the hardware and thermal failures on your Dell OptiPlex XE from a
remote, centralized location. You can monitor the status of your computer
through the Dell Client Manager (DCM) version 3.0 or higher.
TruManage is pre-installed on your computer. However, you need to enable and
set it up to use it.
Enabling TruManage
You can enable TruManage using either one of the following:
•
System Setup (BIOS)
•
Dell Client Manager
Enabling TruManage using System Setup (BIOS)
1
Turn on the computer and press the <F2> key when you see the Dell logo.
The BIOS screen appears.
2
Select
Maintenance
→
System Management
.
3
Select the
DASH/ASF
support checkbox. This enables TruManage.
4
Save and exit. The computer will restart.
Enabling TruManage using Dell Client Manager
You can remotely enable TruManage by using DCM. To enable TruManage on
the client computer, you need to ensure that the Low Power Mode (LPM) is
disabled (for more information, see Low Power Mode).
1
Launch DCM.
NOTE:
For more information, see the Dell Client Manager documentation.
January 2010