Dell PowerConnect 3424 User's Guide Addendum (.pdf) - Page 8

PowerConnect 3424/3448 Release Notes Viewing Statistics Æ Viewing RMON Statistics Æ Viewing RMON History Table Oversize Packets - Number of oversized packets (over 1632 octets) received on the interface since the device was last refreshed. Jabbers - The number of packets received during this sampling interval that were longer than 1632 octets (excluding framing bits but including FCS octets), and had either a bad Frame Check Sequence (FCS) with an integral number of octets (FCS Error) or a bad FCS with a non-integral number of octets (Alignment Error). Dropped Events - counter is not supported. (and not as indicated) Corrections and Additions to the CLI Reference Guide CLI Command Copy spanning-tree pathcost method spanning-tree portfast service cpu-utilization switchport access vlan switchport general allowed vlan switchport general pvid show vlan Description of Change The range of the source-url and destination-url in the command copy source-url destination-url should be 1 - 128 characters. In the command spanning-tree pathcost method {long | short}, long specifies that defaults are per long pathcost method, and short specifies that defaults are per short pathcost method. The default path cost for interface are per the path cost method specified. The following indicates default path cost per method selected: Interface Long Method Short Method Port-channel 20,000 4 Gigabit Ethernet 20,000 4 Port Fast Ethernet Port 200,000 19 Ethernet (10 Mbps) 2,000,000 100 Syntax is changed to: spanning-tree portfast [auto] auto - Specifies that the software waits for three seconds (with no BPDUs received on the interface) prior to transitioning the interface to PortFast mode. The default mode is auto. By default, the cpu-utilization collection is enabled. An interface can only be assigned to "dynamic VLAN" if it is not a member of any VLAN except the default VLAN. An interface can be assigned to "dynamic VLAN" only if it is in access mode. Note that the default port mode for all ports is "access". When an interface in General Mode is configured with a PVID, this interface is not automatically added as a member of the VLAN with that VID. show vlan mac-to-vlan power inline Syntax of command is "show vlan mac-to-vlan" and not as documented. The syntax of the command is not as written, and should be power inline [auto | never] System Firmware Version 2.0.0.20 Subject to Change Without Notice Page 5