Dell PowerConnect 5524 Getting Started Guide - Page 13

Configuring the Switch This section describes the configuration that must be performed after the switch is installed and connected to power supplies. Additional advanced functions are described in the Dell PowerConnect 5500 Series User Guide on the Documentation CD. NOTE: Before proceeding further, read the release notes for this product. You can download the release notes from the Dell Support website at support.dell.com. NOTE: We recommend that you obtain the most recent revision of the user documentation from the Dell Support website at support.dell.com. Configuration Work Flow To configure the switches: 1 For each switch in the stack: a Connect it to a terminal, as described in the "Connecting the Switch to the Terminal". b Boot the switch, as described in the "Booting the Switch". c Assign a unit ID to the switch, as described in "Unit ID Assignment". 2 Connect the units in the stack to each other, as described in "Configuring the Stack". 3 Connect the Master unit to the terminal, reboot the unit and the Setup Wizard is run automatically, as described in "Configuration Using the Setup Wizard". 4 Respond to the Setup Wizard prompts. 5 Continue managing the switch, either through the console or Telnet, using the CLI or the web GUI, as described in the Dell PowerConnect 5500 Series User Guide. Getting Started Guide 13