Dell PowerConnect 6224 Release Notes - Page 19
Issues Resolved - powerconnect switch id
View all Dell PowerConnect 6224 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
PowerConnect 6224/6224F/6224P/6248/6248P Release Notes Issues Resolved The following is a list of issues resolved in the current firmware release. Description Unable to configure IPv6 host (4001::2) as an SNMP trap receiver on the DUT. WFB: Logging messages show UTC time only. Web: Zone config incorrect with summer time config. MLD Packets are not snooped, when sending MLD packets with Hop-by-Hop header with Router Alert Option. Firmware missing no command to remove switch x priority x. Missing RFC1213 MIB-2 SNMP Trap counter. Member xx changes do not result in prompt to save running-config on reload. Cut-through mode does not show in running-config. Asset-tag is not set on stack members. GVRP CLI vs. GUI inconsistency. Configured non-existing host cannot be deleted for logging syslog. Syslog server CLI description accepts invalid control characters User Impact User is not aware that the only IPv4 address is accepted by the command snmp-server host and so may try to give IPV6 address as input. Logging messages show UTC time instead of updated time with timezone offset. Zone is not correctly populated on the web page with the summertime taken into consideration. PC6200 cannot properly identify IPv6 MLD packets that have the hop-by-hop option set like other chips such as FP2. The no switch 2 priority 2 command does not work. There is no no form for User could not walk all objects in SNMP group. If there is an unsaved member, standby, or NSF configuration, user is not warned of the unsaved configuration on issuing reload. The user cannot determine how cutthrough mode is configured via the show running-config command. If a user would run the show system id on the stack member, the asset tag would not be displayed. CLI and Web field names are different and used reverse to each other. Configured non-existing host cannot be deleted for logging syslog. Validation for syslog description is different between Web and CLI. Resolution Updated the help string to mention that IPv4 address is expected as input for snmp-server host CLI command. Used simAdjustedTimeGet() function for correcting log messages time. Added an object to get the information on summertime check and based on this value, populating the zone in the web page. Added a new MLD rule to the FFP which will trap to the CPU IPv6 Membership reports which use the well known MAC address 33:33:00:00:00:16. Added the no version of the command, setting the value to the default. Re-enabled objects to provide support even though the objects were obsoleted in RFC Set the unitMgrCfgFile -> dataChanged flag in the respective APIs. Added a comment to the running config to indicate when the switch is configured in cut-through mode. The switch must be rebooted for the cutthrough configuration to be changed. Process SET_ASSET_TAG event while in connected_unit/connected_stby state. Make the Web field names similar to those of CLI such that the configuration is understood correctly. Corrected logic so that only valid servers could be deleted. Added validation for syslog description in CLI to accept control characters: 'a-z' | 'A-Z' | '0-9 System Firmware Version 3.2.0.6 Page 17