Dell PowerConnect 8100 PowerConnect_8100_interoperability_with_Cisco_Catalyst - Page 13
Creating and connecting LAGs using LACP, Enabling Spanning Tree, RSTP vs. RPVST
View all Dell PowerConnect 8100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Deploying the Dell PowerConnect 8100 with the Cisco Catalyst Run the commands below to configure a trunk port on a single interface with the native VLAN being configured for 2. Cat6504E_1(config)#interface te2/6 Cat6504E_1(config-if)#switchport Cat6504E_1(config-if)#switchport trunk encapsulation dot1q Cat6504E_1(config-if)#switchport trunk allowed vlan 100,101 Cat6504E_1(config-if)#switchport trunk native vlan 2 Cat6504E_1(config-if)#switchport mode trunk Cat6504E_1(config-if)#no shutdown Cat6504E_1(config-if)#exit Creating and connecting LAGs using LACP LACP provides a method of bundling several connections together as a logical link and provides a logical link indicator for this set of connections. In addition, there may be a need to have additional connectivity between two switches for throughput and redundancy. More than one connection can then be bundled as a LAG (link aggregation group). With this LACP type LAG in place, if one or the other of the switches were to crash but yet leave the physical link up, an LACP timeout would signal that the link is disconnected. If LACP were not used in this situation, there would be no indication of the switch on the other end malfunctioning. An example of CLI necessary to create and assign port-channels (LAGs) is found on page 9 and 10. The only note to remember is that the Cisco switches support a proprietary form of LAGs with the PaGP feature that the Dell PowerConnect switch does not support. Enabling Spanning Tree - RSTP vs. RPVST+ Spanning tree protocol (STP) is a Layer 2 protocol that protects a network from loops and broadcast storms. There are several spanning tree methods that can be implemented, but not all are compatible with each other, from one equipment manufacturer to the next. For example, standards-based switches like the Dell PowerConnect 8100 do not use Cisco proprietary protocols (PVST, RPVST, CDP, VTP, and so on.). For this reason, it is important to understand a few terms around standard and non-standard spanning tree. STP (based on IEEE 802.1d) - Spanning Tree Protocol, or simply Spanning Tree. A standards-based protocol that prevents physical loops and broadcast storms on a network. Available on the Dell PowerConnect 8100. 13