Dell PowerConnect Brocade M5424 Brocade 7.1.0 Access Gateway Administrator's G - Page 61
Port Grouping policy, How port groups work
View all Dell PowerConnect Brocade M5424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Port Grouping policy 3 Port Grouping policy Use the Port Grouping (PG) policy to partition the fabric, host, or target ports within an AG-enabled module into independently operated groups. Use the PG policy in the following situations: • When connecting the AG module to multiple physical or virtual fabrics. • When you want to isolate specific hosts to specific fabric ports for performance, security, or other reasons. How port groups work Create port groups using the ag --pgcreate command. This command groups N_Ports together as "port groups." By default, any F_Ports mapped to the N_Ports belonging to a port group will become members of that port group. Port grouping fundamentally restricts failover of F_Ports to the N_Ports that belong to that group. For this reason, an N_Port cannot be member of two port groups. The default PG0 group contains all N_Ports that do not belong to any other port groups. Figure 9 shows that if you have created port groups and then an N_Port goes offline, the F_Ports being routed through that port will fail over to any of the N_Ports that are part of that port group and are currently online. For example, if N_Port 4 goes offline, then F_Ports 7 and 8 are routed through to N_Port 3 as long as N_Port 3 is online because both N_Ports 3 and 4 belong to the same port group, PG2. If no active N_Ports are available, the F_Ports are disabled. The F_Ports belonging to a port group do not fail over to N_Ports belonging to another port group. F_Port1 F_Port2 F_Port3 F_Port4 F_Port5 F_Port6 F_Port7 F_Port8 N_Port1 N_Port2 AG N_Port3 N_Port4 PG1 Fabric-1 Fabric-2 Storage Array-1 Storage Array-2 FIGURE 9 PG2 Port grouping behavior When a dual redundant fabric configuration is used, F_Ports connected to a switch in AG mode can access the same target devices from both of the fabrics. In this case, you must group the N_Ports connected to the redundant fabric into a single port group. It is recommended to have paths fail over to the redundant fabric when the primary fabric goes down. Refer to Figure 10. Access Gateway Administrator's Guide 41 53-1002743-01