Dell PowerConnect W-IAP134 Dell Instant 6.2.0.0-3.2.0.0 User Guide - Page 46
Virtual Controller assigned, Network, assigned, The Virtual Controller NATs all traffic
View all Dell PowerConnect W-IAP134 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Figure 31 - Adding an Employee Network- VLAN Tab 5. Select the required Client IP assignment option - Virtual Controller assigned or Network assigned. Table 5 - Conditions for Client IP and VLAN assignment If you select then Virtual Controller assigned The client obtains the IP address from the Virtual Controller. The Virtual Controller creates a private subnet and VLAN on the WIAP for the wireless clients. The Virtual Controller NATs all traffic that passes out of this interface. This setup eliminates the need for complex VLAN and IP address management for a multi site wireless network. See "Virtual Controller" on page 109 for configuring the DHCP server. Network assigned By default, the client VLAN is assigned to the native VLAN on the wired network. l Default- The client obtains the IP address in the same subnet as the W-IAPs. l Static- Select to specify a single VLAN, a comma separated list of VLANS, or a range of VLANs for all clients on this network. l Dynamic- Select to create rules for peruser VLAN assignment. See "VLAN Derivation Rule " on page 150 for more information. NOTE: Select the Static option in the Client VLAN assignment section to configure VLAN pooling. See "VLAN Pooling" on page 69 for additional details. 6. Click Next to continue. 46 | Wireless Network Dell PowerConnect W-Series Instant Access Point 6.2.0.0-3.2.0.0 | User Guide