Dell PowerEdge 6300 Installing a Microprocessor or Terminator Card - Page 4

1. Turn off the system, including any attached peripherals, and disconnect the AC power cable from its power source. NOTICE: See "Protecting Against Electrostatic Discharge" in the safety instructions at the front of your computer's Installation and Troubleshooting Guide. 2. Remove the computer cover. See "Checking Inside the Computer" in your system's Installation and Troubleshooting Guide for more information. 3. Remove the cooling shroud. See "Checking Inside the Computer" in your system's Installation and Troubleshooting Guide for more information. 4. Lift the latches on each end of the guide bracket assembly (see Figure 1). Pivot the retention clips away from the guide bracket assembly, then slide the SEC cartridge or terminator card out of the guide bracket assembly. heat sink SEC cartridge retention clips (2) guide-bracket assembly latches (2) Figure 1. Removing a Microprocessor or Terminator Card 2 Dell PowerEdge 63xx Systems-Installing a Microprocessor or Terminator Card