Dell PowerEdge 6850 Information Update (.pdf) - Page 1

Dell PowerEdge 6850 Manual

Page 1 highlights

www.dell.com | support.dell.com R9283am0.fm Page 1 Wednesday, March 2, 2005 3:20 PM Information Update For instructions on installing your Dell™ 2362M Integrated Fibre Channel Module, refer to the PowerEdge™ 6850 Installation and Troubleshooting Guide. Configuration information, drivers, and a list of EMC-approved software are available on support.dell.com. Using the StorPort Driver with the Microsoft® Windows® Server 2003 Operating System If you are using the StorPort driver with the Microsoft Windows Server 2003 operating system and do not have Service Pack 1 or later installed, make sure you are using the latest storport.sys driver. Updated StorPort drivers are available from www.microsoft.com. For the latest required hotfix, see http://www.qlogic.com/go/emc_approved. QLogic SANSurfer SANblade Manager QLogic SANSurfer SANblade Manager version 2.0.30 Build 17 or later supports the Dell 2362M Integrated Fibre Channel Module card for the PowerEdge 6850. If you are using an earlier version, see support.dell.com or www.qlogic.com to update your SANSurfer application. Brocade SilkWorm 4100 Port Synchronization When using Fabric Operating System version 4.4.0b or earlier, port synchronization may fail. To avoid this problem, set the topology to loop-first and point-to-point. This corresponds to the default NVRAM settings. An update that resolves this issue will be available at www.brocade.com. Version Display at System Boot During system boot, the Dell 2362M Integrated Fibre Channel Module is displayed as QLA2322. Information in this document is subject to change without notice. © 2005 Dell Inc. All rights reserved. Printed in the U.S.A. Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell, PowerEdge, and the DELL logo are trademarks of Dell Inc.; EMC is the registered trademark of EMC Corporation; Microsoft and Windows are registered trademarks of Microsoft Corporation. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own. March 2005

  • 1

www.dell.com | support.dell.com
Information Update
For instructions on installing your Dell
2362M Integrated Fibre Channel Module, refer to the
PowerEdge
6850
Installation and Troubleshooting Guide
. Configuration information, drivers, and
a list of EMC-approved software are available on
support.dell.com
.
Using the StorPort Driver with the Microsoft
®
Windows
®
Server 2003 Operating System
If you are using the StorPort driver with the Microsoft
Windows Server 2003 operating system and
do not have Service Pack 1 or later installed, make sure you are using the latest
storport.sys
driver.
Updated StorPort drivers are available from
www.microsoft.com
. For the latest required hotfix, see
.
QLogic SANSurfer SANblade Manager
QLogic SANSurfer SANblade Manager version 2.0.30 Build 17 or later supports the Dell 2362M
Integrated Fibre Channel Module card for the PowerEdge 6850. If you are using an earlier version,
see
support.dell.com
or
www.qlogic.com
to update your SANSurfer application.
Brocade SilkWorm 4100 Port Synchronization
When using Fabric Operating System version 4.4.0b or earlier, port synchronization may fail. To
avoid this problem, set the topology to loop-first and point-to-point. This corresponds to the
default NVRAM settings. An update that resolves this issue will be available at
www.brocade.com
.
Version Display at System Boot
During system boot, the Dell 2362M Integrated Fibre Channel Module is displayed as
QLA2322
.
___________________
Information in this document is subject to change without notice.
© 2005 Dell Inc. All rights reserved. Printed in the U.S.A.
Reproduction in any manner whatsoever without the written permission of Dell Inc.
is strictly forbidden.
Trademarks used in this text:
Dell
,
PowerEdge
, and the
DELL
logo are trademarks of Dell Inc.;
EMC
is the registered trademark
of EMC Corporation;
Microsoft
and
Windows
are registered trademarks of Microsoft Corporation.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names
or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.
March 2005
R9283am0.fm
Page 1
Wednesday, March 2, 2005
3:20 PM