Dell PowerEdge 860 Getting Started Guide - Page 5

System Features The major hardware and software features of your system include: • 1U/1S rack-mountable chassis with support for static rails and sliding rails. NOTE: Use the System Setup program to view processor information. See "Using the System Setup Program" in your Hardware Owner's Manual. • One of the following processors: - One Intel® Core™ 2 Duo - One Intel Celeron® D, 300 Sequence - One Intel Pentium® 4, 600 Sequence • A minimum of 512 MB of 533-MHz or 667-MHz DDR2 SDRAM memory, upgradable to a maximum of 8 GB by installing combinations of 512-MB, 1-GB, or 2-GB unbuffered ECC memory modules in four memory module sockets on the system board. • One of the following riser card options: - One full-height, half-length, x8 lane PCIe expansion slot and one full-height, half-length PCIe expansion slot with a x8 connector but with a x4 lane capability. - One full-height, half-length, 133MHz/64 bit PCI-X expansion slot and one full-height, halflength, x8 lane PCIe expansion slot, which includes a connector for an optional remote access controller (RAC) card. • One 3.5-inch CD, DVD, or combination CD-RW/DVD in a peripheral drive bay. • Support for the following internal hard-drive configurations: - Up to two internal, 1-inch high, SATA hard drives with the integrated drive controllers. - Up to two internal, 1-inch high optional Serial-Attached SCSI (SAS) hard drives with an optional SAS controller card. • Optional remote access controller for remote systems management. This option requires a riser card with support for PCI-X and PCIe RAC connectors. • Optional USB flash drive emulates a diskette drive or hard drive. • One 345-W power supply. • Two integrated Gigabit Ethernet network adapters, capable of supporting 10-Mbps, 100-Mbps, and 1000-Mbps data rates. Getting Started With Your System 3