Dell PowerEdge FC830 Dell PowerEdge FC830 Owners Manual - Page 90
hard-drive/SSD backplane cable
View all Dell PowerEdge FC830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
4. Remove the hard drive(s)/SSD(s). Steps 1. Disconnect the power cable from the hard drive/SSD backplane. 2. Loosen the retention screws securing the hard drive/SSD backplane to the hard drive/SSD cage. 3. Lift the hard drive/SSD backplane by its edges until the retention screws disengage from the screw holes on the hard drive/SSD cage. 4. Remove the hard drive/SSD cage. See Removing the hard drive/SSD cage. 5. Loosen the retention screws securing the hard-drive/SSD backplane cable connector to the system board connector. 6. Lift the backplane away from the system. Figure 33. Removing a 2.5 inch (x8) SATA hard drive/SSD backplane 1. alignment pin (2) 3. retention screw on the top of the hard drive/SSD backplane (4) 5. hard-drive/SSD backplane cable connector 7. retention screw on the bottom of the hard drive/SSD backplane (4) 2. power cable 4. hard drive/SSD backplane 6. hard drive/SSD backplane cable 8. screw holes on the hard drive/SSD cage (6) Next steps 1. Install the hard drive/SSD backplane. Related Links Installing a 2.5 inch (x8) SATA hard drive/SSD backplane 90