Dell PowerEdge M1000e Rack Installation Guide - Page 20
Installing the System in the Rack - chassis
View all Dell PowerEdge M1000e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Installing the System in the Rack CAUTION: If you are installing more than one system, install the first system in the lowest available position in the rack. CAUTION: Never pull more than one component out of the rack at a time. CAUTION: Because of the size and weight of the system, never attempt to install the system in the rack by yourself. CAUTION: It is recommended that more than one person assist in lifting the system. NOTICE: It is recommended that you use a lift table to aid in installing the system in the rack, particularly if the rail assemblies are more than waist-high. NOTICE: When you are lifting and installing your system in the rack, avoid grasping the LCD module on the front of the system as this part is fragile. See Figure 1-7. NOTE: If you are transporting a system that is already installed in the rack, ensure that the two rack stabilizer mounting brackets are in place. • Locate the lower clinch nut holes on either side of the rack just below the default position for the strain-relief bar. • To identify the default position of the strain-relief bar and the attachment points for the stabilizer mounting brackets, see Figure 1-8. 1 Remove all blades, rear modules, power supplies, and fans before installing your system in the rack. 2 Lift the system into position to install it in the rack. It is recommended that more than one person assist in lifting the system. 3 Guide the system into the rack and lower the system onto the rail assemblies (see Figure 1-7). 4 Tighten the thumbscrews on the chassis front panel. 5 Reinstall the blades, rear modules, power supplies, and fans. 18 Rack Installation Guide