Dell PowerEdge M620 Dell PowerConnect M8024-k Release Notes - Page 20
No user impact expected.
View all Dell PowerEdge M620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Summary Max number of OSPF neighbors not supported Cable fault distance not getting displayed in WEB in case of cable with one or more pairs cut or short. Ports representation need to be changed in debug messages No error message for illegal characters in various command parameters The ARP entry is not seen in the ARP table when an ARP reply is sent to DUT. Mapping Table configuration is not being displayed on Read-Only mode user web page. ACL is getting deleted when trying to create max+1 rule. LLDP-Med TLV information not registered for jumbo frame sizes greater than 8000 VLAN binding entries are not being displayed on Read-Only mode user web page. Unable to execute the command dot1x timeout tx-period 1 In switching> network security >dot1x authentication web page in read-only user mode, the Re-Authenticate Now check box can be checked System Device information web page LED information not in sync with front panel LED information. DHCP snooping static binding thru DHCP request is denied as this is a expected behavior. Mode of transfer is displaying "unknown," while downloading the code from ftp Allow disabling and enabling of terminal paging Web does not allow to configure image descriptor to its max length i.e. 255 characters. User Impact User confusion over switch operations. User confusion over switch operations. User confusion over switch operations. Inability to diagnose network issues. User confusion over switch configuration. User confusion over switch operations. Inability to diagnose network issues. User confusion over switch configuration. User confusion over switch operations. Possible security issues. User confusion over switch operations. User confusion over switch operations. User confusion over switch operations. User confusion over switch operations. Possible security issue. No user impact expected. User confusion over switch operations. User confusion over switch operations. User frustration over switch configuration. User confusion over switch operations. Workaround The maximum number of neighbors is supported. The fault distance is displayed in the web page. Ports are now displayed in C/S/P standard format The accepted character set and length is documented in the CLI reference manual. ARP entries are stored properly The mapping table is displayed for a readonly user. Corrected error checking logic. Jumbo LLDP frames are now processed properly VLAN binding entries are available to read only users This command is accepted with a timeout period of 1 second. Corrected range check on input. Read-only properties are set for the check box This issue was regarding various stylistic aspects of the system device web page. The system device web page conforms to the requirements as it exists and does necessarily match the CLI with regarding to capitalization or naming conventions Removed the log message indicating that a bound DHCP client with an existing binding sent a DISCOVER. Added a counter for this condition to the DHCP debug statistics. ftp transfer mode is displayed The terminal length command is now implemented. Images descriptors up to 255 characters are allowed 18 System Firmware Version 4.1.0.6