Dell PowerEdge M710 Fabric OS Message Reference - Page 89
Support, Panic Dump and Core Dump Files, Trace Dumps, supportSave Command, System Module Descriptions
![]() |
View all Dell PowerEdge M710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
System Module Descriptions 1 Support Fabric OS creates a number of files that can help support personnel troubleshoot and diagnose a problem. This section describes those files and how to access and/or save the information for support personnel. Panic Dump and Core Dump Files The Fabric OS creates panic dump files and core files when there are problems in the Fabric OS kernel. You can view panic dump files using the pdShow command. These files can build up in the kernel partition (typically because of failovers) and might need to be periodically deleted or downloaded using the supportSave command. The software watchdog process (SWD) is responsible for monitoring daemons critical to the function of a healthy switch. The SWD holds a list of critical daemons that ping the SWD periodically at a predetermined interval defined for each daemon. The ping interval is set at 133 seconds, with the exception of the Fabric Watch daemon and the IP storage demon, which ping the SWD every 333 seconds. (For a complete listing of daemons, see the KSWD entry in Table 5.) If a daemon fails to ping the SWD within the defined interval, or if the daemon terminates unexpectedly, then the SWD dumps information to the panic dump files, which helps to diagnose the root cause of the unexpected failure. Run the pdShow command to view these files or the supportSave command to send them to a host workstation using FTP. The panic dump files and core files are intended for support personnel use only. Trace Dumps The Fabric OS produces trace dumps when problems are encountered within Fabric OS modules. The Fabric OS trace dump files are intended for support personnel use only. You can use the supportSave or supportFTP commands to collect trace dump files to a specified remote location to provide to support when requested. supportSave Command The supportSave command can be used to send the output of the system messages (RASLog), the trace files, and the output of the supportShow command to an off-switch storage location through FTP. Prior to running the supportSave command, you can optionally set up the FTP parameters using the supportFtp command. The supportShow command runs a large number of dump and show commands to provide a global output of the status of the switch. Refer to the Fabric OS Command Reference for more information on these commands. System Module Descriptions NOTE Any reference seen in a system message to slot 0 is a reference to the blade within the switch platform, for example: Brocade DCC contains FC8-48, FC9-32, and FC8-16 blades. Fabric OS Message Reference 13 53-1001767-01
![](/manual_guide/products/dell-8-fabric-os-message-reference-b23513f/89.png)