Dell PowerEdge M805 Dell M8428-k Getting Started Guide - Page 6
Configuring the converged network switch, Items required
View all Dell PowerEdge M805 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Configuring the converged network switch Use procedures in this section to configure the converged network switch to operate on a network and fabric. Also provided are steps to change the module's operating mode (NPIV aggregator and full fabric modes) and connecting to the converged network switch using the browser-based GUI. NOTE Although the converged network switch is configured at the factory for NPIV mode, you can disable NPIV mode. Refer to procedures under "Changing from NPIV aggregator mode to full fabric mode" on page 10. This publication provides procedures that use the switch module Command Line Interface (CLI) and the browser-based GUI application. If the same operation can be performed using the Blade Server chassis management application, use that application instead. Items required The following items are required for configuring and connecting the converged network switch for use in a network and fabric: • The converged network switch installed in a Blade Server Enclosure. For instructions, refer to the steps on installing an I/O module in the Hardware Owner's Manual for the Blade Server Enclosure. • If required, management workstation (computer) that has a terminal emulator (such as HyperTerminal) or a keyboard, video, and mouse (KVM) device. Note that this is only required if not changing the converged network switch IP address through the Blade Server Enclosure GUI or CLI management programs. • An unused IP address and corresponding subnet mask and gateway address unless DHCP is used. • If required, a serial cable to connect to the switch module serial console port. Note that this is only required if not changing the switch module IP address through the Blade Server Enclosure GUI or CLI management programs. • SFP transceivers and compatible fibre cables, as required. The switch module can also use twin-ax copper cables. NOTE Use only Dell-approved SFPs on the external ports of this module. • Access to an FTP server for backing up the converged network switch configuration. • Access to these publications: • Blade Server Enclosure Hardware Owner's Manual • Blade Server Enclosure Configuration Guide 4 of 160 Dell M8428-k Getting Started Guide MHWKY