Dell PowerEdge M820 Hardware Owner's Manual - Page 273
Installing a CMC Module, Chassis, Power Management, Control, Reset CMC, Apply
View all Dell PowerEdge M820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 273 highlights
3 Reinstall the CMC module and reattach any cables that were disconnected. See "Installing a CMC Module" on page 273. On a single CMC system, the SD card activates automatically. For redundant CMC module systems, initiate a changeover to make the passive module active using the following steps: 1 Navigate to the Chassis page. 2 Click the Power Management tab. 3 Click the Control sub tab. 4 Select the Reset CMC (warm boot) button. 5 Click Apply. The CMC will automatically fail over to the redundant module, and that module now becomes active and displays a solid blue status LED. The SD card activates automatically. See the CMC User's Guide for information on configuration and usage of the FlexAddress feature. Installing a CMC Module 1 Remove the I/O connector cover. See Figure 4-4. 2 Ensure that the CMC module handle is fully open. 3 Slide the module into the enclosure until the handle contacts the enclosure. 4 To fully seat the module, close the handle until the release latch snaps into place. 5 Reconnect the cables that were attached to the module. Installing Enclosure Components 273