Dell PowerEdge R750 EMC PMem 200 Series Users Guide - Page 16

App-direct mode configuration, Create goal

Get Dell PowerEdge R750 PDF manuals and user guides View all Dell PowerEdge R750 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

NOTE: PMems are shown as DIMMs. There is one entry for each PMem that is installed and the current health and status information for each PMem is displayed as: Figure 3. Memory information NOTE: Data is always assumed to be in units of MiB/GiB/TiB even if labeled MB/GB/TB. User capacity overhead is up to 2% of capacity (GiB). Another overhead may be required for Regions, Namespace, and Filesystems. NOTE: The default value of the Persistent Memory DIMM Overwrite DIMM status for PMem 100 Series is not started while the Persistent Memory DIMM Overwrite DIMM status for PMem 200 Series is Unknown after long operation. Unknown - The overwrite PMem module operation status cannot be determined. This may occur if the status gets overwritten due to a different long operation running on this PMem module. This unknown status is expected behavior. App-direct mode configuration Create goal Goal is created in BIOS. To create a goal in BIOS, go to: Memory Settings > Persistent Memory > Intel Persistent Memory > Region Configuration > Create Goal Config. 16 BIOS

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
NOTE:
PMems are shown as DIMMs.
There is one entry for each PMem that is installed and the current health and status information for each PMem is displayed as:
Figure 3. Memory information
NOTE:
Data is always assumed to be in units of MiB/GiB/TiB even if labeled MB/GB/TB. User capacity overhead is up to
2% of capacity (GiB). Another overhead may be required for Regions, Namespace, and Filesystems.
NOTE:
The default value of the Persistent Memory DIMM Overwrite DIMM status for PMem 100 Series is
not started
while the Persistent Memory DIMM Overwrite DIMM status for PMem 200 Series is
Unknown
after long operation.
Unknown
- The overwrite PMem module operation status cannot be determined. This may occur if the status gets
overwritten due to a different long operation running on this PMem module. This
unknown
status is expected behavior.
App-direct mode configuration
Create goal
Goal is created in BIOS.
To create a goal in BIOS, go to:
Memory Settings
>
Persistent Memory
>
Intel Persistent Memory
>
Region
Configuration
>
Create Goal Config
.
16
BIOS