Dell PowerStore 1200T EMC PowerStore Power Down and Reboot Procedures Guide - Page 13
Power off a PowerStore T model appliance, Management IPs
View all Dell PowerStore 1200T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
● Power off a PowerStore T model appliance on page 13 ● Power off a PowerStore X model appliance on page 13 Power off a PowerStore T model appliance Prerequisites ● Do not power off the appliance if you are replacing a hardware component. Identify the node that includes the faulted hardware component, and power off only that node. For more information, see Power off a PowerStore T model node using PowerStore Manager on page 7. ● Powering off an appliance results in the mapped hosts losing access to the data on the appliance. Before you begin, ensure that you temporarily disconnect host access from all storage resources. ● Obtain the following information: ○ Management IP address of the appliance. In PowerStore Manager, go to Settings > Networking > Network IPs > Management. Review the Management IPs table to identify the management IP address associated with the appliance. ○ Service account credentials ○ Service tags of the appliance ○ If applicable, service tags of the associated expansion enclosures About this task Use the following procedure to power off a single PowerStore T model appliance. To power off all of the appliances in a cluster, see Power off a PowerStore T model cluster on page 16: Steps 1. Log in to PowerStore Manager. 2. Determine the primary appliance by going to Settings > Cluster > Properties. 3. If the appliance you are shutting down is the primary appliance: a. Launch an SSH client, and connect to the appliance using the management IP address. b. Enter the username and password that is associated with the service account, and log in. c. Run the following command to specify which appliance you want to become the new primary appliance: svc_cluster_management MoveMasterAppliance 4. In PowerStore Manager, under Hardware, select the appliance that you want to power off. 5. Under More Actions, select Power Down. The Validation window opens. 6. Review any errors, warnings, and recommendations. Once the appliance passes all of the validation checks, click Next. The Active Objects window opens. 7. Review the list of objects on the appliance that had I/O activity during the last five minutes. 8. Click Next. The Confirm window opens. 9. Enter the service password, and click Power Down. 10. Check the status of the LEDs in the rear of chassis to verify that the appliance has powered off. Other than the LEDs for the power supply unit, management port, and service port, all other LEDs on the appliance must be OFF. 11. Wait five minutes, and then disconnect the power cables from the base enclosure. 12. Disconnect the power cables from any associated expansion enclosures. Power off a PowerStore X model appliance Prerequisites ● Do not power off the appliance if you are replacing a hardware component. Identify the node that includes the faulted hardware component, and power off only that node. For more information, see Power off a PowerStore X model node on page 8. ● Ensure that SSH is enabled on the ESXi host and configured to start automatically. Power control procedures 13