Dell PowerSwitch S4820T 9.40.0 Command Line Reference Guide for the S4820T Sys - Page 1356

Version 9.0.2.0 Version 8.3.19.0 Version 8.3.11.1 Version 8.3.7.0 Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Usage Information Related Commands To access this command, enter the class-map command. After the class map is identified, you can configure the match criteria. The match ip dscp and match ip precedence commands are mutually exclusive. Up to 64 IP DSCP values can be matched in one match statement. For example, to indicate IP DCSP values 0 1 2 3 4 5 6 7, enter either the match ip dscp 0,1,2,3,4,5,6,7 or match ip dscp 0-7 command. NOTE: Only one of the IP DSCP values must be a successful match criterion, not all of the specified IP DSCP values must match. class-map - identifies the class map. match ip precedence Use IP precedence values as a match criteria. S4820T Syntax match ip precedence ip-precedence-list [[multicast] set-ip-dscp value] To remove IP precedence as a match criteria, use the no match ip precedence ip-precedence-list [set-ip-dscp value] command. Parameters ipprecedence-list set-ip-dscp value Enter the IP precedence value(s) as the match criteria. Separate values by commas - no spaces ( 1,2,3 ) or indicate a list of values separated by a hyphen (1-3). The range is from 0 to 7. (OPTIONAL) Enter the keywords set-ip-dscp then the IP DSCP value. The matched traffic is marked with the DSCP value. The range is from 0 to 63. Defaults Command Modes Command History none CLASS-MAP CONFIGURATION (config-class-map) This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. 1356 Quality of Service (QoS)