Dell PowerVault MD1000 Getting Started Guide: (English, Brazilian Portuguese, - Page 10
Technical Specifications, Drives, Connectivity, Enclosure Management Modules, Backplane Board
View all Dell PowerVault MD1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Technical Specifications Drives SAS hard drives up to 15 1-inch-by-3.5-inch SAS hot-plug hard drives (3.0 Gbps) at speeds of 10K or 15K rpm (See your system readme file for supported disk capacities.) SATA hard drives up to 15 1-inch-by-3.5-inch SATA hot-plug hard drives (3.0 Gbps) at speeds of 7.2K rpm. Connectivity to the system backplane is provided through an interposer assembly. Connectivity Configurations support for either of the following configurations: • unified mode for direct connectivity to 15 hard drives • split mode with dual EMMs providing a direct connectivity to drives 0 though 6 and a separate direct connectivity to drives 7 though 14 Enclosure Management Modules EMMs 1 or 2 modules Sensors 1 sensor per EMM Backplane Board Connectors • 15 SAS hard-drive connectors • 2 power supply/cooling fan module connectors • 2 sets of EMM connectors (6 connectors each EMM) • 1 control panel connector for front LEDs and enclosure mode switch Sensors 2 temperature sensors Back-Panel Connectors SAS connectors (per EMM) • 1 SAS "IN" connector for connection to the host • 1 SAS "OUT" connector for expansion to an additional enclosure Serial connector (per EMM) 1 6-pin UART mini-DIN connector (for factory use only) 8 Getting Started With Your System