Dell PowerVault NX200 Placemat - Page 1

Setting Up Your Dell PowerVault NAS Solution WARNING: Before you set up and operate your Dell PowerVault system, review the safety instructions that came with your system. Dell Software License Agreement • Before using your system, please read the Dell Software License Agreement that came with your system. • You must consider any CD, DVD, or diskette set of Dell installed software as BACKUP copies of the software installed on your system's hard-disk drive. • If you do not accept the terms of the agreement, please call the customer assistance telephone number. For customers in the United States, call 800-WWW-DELL (800-999-3355). For customers outside the United States, visit support.dell.com, click your country/region at the bottom of the page. For a full listing of country/region click All. Click All Support Options from the Support menu. Verify Package Contents Verify that all components listed on your packing slip are available. Save all documentation and accessories. Locating Your System Service Tag • Your system is identified by a unique Express Service Code and Service Tag number. The Express Service Code and Service Tag are found on the top of the system. • This information is used by Dell to route support calls to the appropriate personnel. Default Password The default password for the network attached storage (NAS) system is Stor@ge! Default System Name Your system is configured with a default system name of D, where is the Service Tag number located on the system. 1 Before You Begin Check for documentation and information updates on support.dell.com/manuals. Always read the updates first because they often supersede information in other documents. 1 2 PowerVault NX200 storage system 1. Gb1 to Ethernet switch 2. Gb2 to Ethernet switch NOTE: Before turning on your system, ensure that you connect the system to a grounded electrical outlet. 2 System Cabling Connection Procedure Using a Remote Desktop If Dynamic Host Configuration Protocol (DHCP) and Domain Name System (DNS) are implemented on your network, your system automatically configures the network settings. You can launch Remote Desktop from a client and remotely access the NAS system using the default system name. For example, in the Remote Desktop Connection window, type D where is the Service Tag number located on the system. Using a Keyboard, Monitor, and Mouse Connect a keyboard, monitor, and mouse directly to the NAS system for local administration. NOTE: You can also use the iDRAC interface (optional) for remote administration. For information about initial setup, configuring iDRAC, and console redirection, see the integrated Dell remote access controller User's Guide at support.dell.com/manuals. 3 Power-Up and Connection Procedure