Dell PowerVault TL2000 Dell Model TL24iSCSIxSAS 1Gb iSCSI to SAS - User's G - Page 53

Appendix C, 4 Step 3 - Targets

Get Dell PowerVault TL2000 PDF manuals and user guides View all Dell PowerVault TL2000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 53 highlights

13.4 Step 3 - Targets Click on the Targets tab. The devices discovered should now be listed and shown in Figure 38. Appendix C Figure 38 Targets Tab In this example two iSCSI targets have been discovered. The first device is the tape drive, and the second is the media changer. If no devices are displayed, check the settings used to do the discovery, especially the CHAP settings then return to Targets tab and click Refresh. If still no devices are displayed, check network cables and that the iSCSI bridge is operational. To connect to one of the iSCSI Targets, click on one of the target names and then click the 'Log on' button. In this example we have chosen the first target. A window should appear as in Figure 39. Figure 39 Connecting to an iSCSI Target Dell Model TL24iSCSIxSAS 1Gb iSCSI to SAS User's Guide Rev.C Page 51

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
Appendix C
Dell Model TL24iSCSIxSAS 1Gb iSCSI to SAS User’s Guide
Rev.C
Page 51
13.4 Step 3 – Targets
Click on the Targets tab.
The devices discovered should now be listed and shown in Figure 38.
Figure 38 Targets Tab
In this example two iSCSI targets have been discovered.
The first device is the tape drive, and the second is
the media changer.
If no devices are displayed, check the settings used to do the discovery, especially the
CHAP settings then return to Targets tab and click Refresh.
If still no devices are displayed, check network
cables and that the iSCSI bridge is operational.
To connect to one of the iSCSI Targets, click on one of the target names and then click the ‘Log on’ button.
In this example we have chosen the first target.
A window should appear as in Figure 39.
Figure 39 Connecting to an iSCSI Target