Dell Precision M4300 Service Manual (English Only) - Page 14

Back to Contents Page Display Assembly Dell™ Precision™ M4300 Service Manual Removing the Display Assembly Removing the Display Bezel Removing the Display Panel Installing the Display Panel Removing the Display Panel Brackets Removing the Display Latch Removing the Display Assembly CAUTION: Before performing the following procedures, follow the safety instructions in the Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of the computer. 1. Follow the procedures in Before You Begin. 2. Remove the hinge cover (see Hinge Cover). 3. Remove the keyboard (see Keyboard). 4. Pull straight up on the pull-tab that is attached to the display-feed flex cable to disconnect the cable from the system board. 1 antenna cable 2 display cable pull-tab 5. Disconnect the antenna cable(s). 6. Carefully remove the antenna cable and the display cables from their routing guides. 7. Close the display. 8. Turn the computer upside-down with the back of the computer facing you. 9. From the bottom of the computer, remove the two M2.5 x 5-mm screws labeled "D."