Dell S4148U-ON EMC Networking Virtualization Overlay with BGP EVPN - Page 62
Gateway/firewall switch configuration
View all Dell S4148U-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
A A.1 A.2 Gateway/firewall switch configuration This section details the configuration of an S4112F-ON switch used as the external gateway/simulated firewall to validate this deployment example. This switch is connected to the border leafs, Leaf3a and Leaf3b, as shown in Figure 12. Initial configuration settings 1. Enter configuration mode with the configure terminal command. 2. Configure the hostname. 3. If DHCP is not used, configure the OOB management IP address and default gateway. 4. Enable spanning tree protocol as a precaution against loops. Any spanning tree protocol type supported by the switch is acceptable. This example uses RSTP. Initial configuration settings Gateway/firewall switch configure terminal hostname Gateway-FW interface mgmt 1/1/1 no ip address ip address 100.67.166.235/24 no shutdown management route 0.0.0.0/0 100.67.166.254 spanning-tree mode rstp Indirect gateway configuration 1. Configure VLAN 1. 2. Specify the IP address used as the indirect gateway. Gateway configuration Gateway/firewall switch interface vlan1 no shutdown ip address 172.16.16.253/24 62 Dell EMC Networking Virtualization Overlay with BGP EVPN