Dell S5224F-ON EMC PowerSwitch S5200-ON Series BMC User Guide March 2021 - Page 19
Parameter, Parameter data, Flush IPv4 and IPv6 iptable
View all Dell S5224F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Table 3. Firewall parameters (continued) Parameter # Flush IPv4 and IPv6 iptable 8 Drop all 9 Remove drop all rule 10 Add IPv4 address with timeout rule 11 Add IPv4 range of addresses with 12 timeout rule Parameter data Flush all the rules set using iptables and ip6tables. Add iptables rules to block IPv4 and IPv6 traffic to the BMC. The state selector is not used. ● Data1: Protocol ● Bit 7:2-Reserved ● Bit 1-IPv6 ● Bit 0-IPv4 Remove iptables rules to block IPv4 and IPv6 traffic to the BMC. The state selector is not used. ● Data1: Protocol ● Bit 7:2-Reserved ● Bit 1-IPv6 ● Bit 0-IPv4 Data 1:4-IP address ● MS-byte first. The IPv4 address type blocked or unblocked based on the state. ● Date 5:10-Start time ● [5:6]-Year ● LS-byte first if little endian system. Two-byte data required to form year. ● 7-month ● 8-date ● 9-hour ● 10-minute ● Date 11-16-stop time ● [11:12]-Year ● LS-byte first if little endian system. Two-byte data required to form year. ● 13-month ● 14-date ● 15-hour ● 16-minute Data 1:8-IP address ● [1:4]-Starting IP address blocked or unblocked based on the state. ● [5:8]-Ending IP address till IPs are blocked or unblocked based on the state. ● Date 9:14-Start time ● [9:10]-Year ● LS-byte first if little endian system. Two-byte data required to form year. ● 11-month ● 12-date ● 13-hour ● 14-minute ● Date 15-20-Stop time ● [15:16]-Year Configuration methods 19