Dell W-Series 324 320 Series Regulatory Compliance and Safety Information Guid - Page 3

Users are advised that high power radars are allocated as primary users of the bands 5250-5350 MHz and 5650-5850 MHz and these radars could cause interference and/or damage to Licensed Exempt WLAN devices. Canada Complies with the Class B limits for radio noise emissions as set out in the interference-causing equipment standard entitled "Digital Apparatus," ICES-003 of Industry Canada. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that necessary for successful communication. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Déclaration d'Industrie Canada Cet appareil numerique de la classe B respecte toutes les exigencies du Reglement sur le materiel brouilleur du Canada. Conformément aux réglementations d'Industrie Canada, cet émetteur-récepteur radio doit être utilisé uniquement avec une antenne dont le type et le gain maximal doivent être approuvés par Industrie Canada. Pour réduire les interférences radio potentielles, le type d'antenne et son gain doivent être choisis de façon à ce que la puissance isotrope rayonnée équivalente (PIRE) ne dépasse pas les valeurs nécessaires à une communication efficace. Ce périphérique est conforme aux règlements RSS exempts de licence d'Industrie Canada. L'utilisation de ce périphérique est soumise aux deux conditions suivantes : (1) ce périphérique ne doit pas provoquer d'interférences, et (2) ce périphérique doit accepter toute interférence, y compris les interférences susceptibles de provoquer un dysfonctionnement. EMC Class B Warning B EU Regulatory Conformance Dell, hereby declares that this device is in compliance with directives listed below:  EMC Directive 2004  Low Voltage Directive 2006  R&TTE Directive 1999  REACH Regulation (EC) No.: 1907/2006  RoHS Directive 2011  WEEE Directive 2002 The Declaration of Conformity for these directives is available for viewing at dell.com. NOTE: For country specific restrictions and additional regulatory and safety guidelines, refer to the Dell Networking W-Series Safety, Environmental and Regulatory Information document included with Dell controllers and Instant access points. Medical 1. Equipment not suitable for use in the presence of flammable mixtures. 2. Connect to only IEC 60950-1 or IEC 60601-1 3rd edition certified products and power sources. The end user is responsible for the resulting medical system complies with the requirements of IEC 60601-1 3rd edition. 3. Wipe with a dry cloth, no additional maintenance required. 4. No serviceable parts, the unit must be sent back to the manufacturer for repair. 5. No modifications are allowed without Dell approval. Dell Networking 320 Series Access Points | Regulatory Compliance and Safety Information Guide 3