Dell XPS 600 Renegade Owner's Manual - Page 115
the tab, away from the heat sink, until the heat sink pops up
View all Dell XPS 600 Renegade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
5 Remove the heat sink: NOTICE: After the heat sink has been removed, lay the heat sink down on its side to avoid damaging the thermal interface on the bottom. a Remove the retention module clip from the side of the retention base opposite the power supply. Pull the tab on the clip straight out and away from the retention base to remove it. b On the retention base locate the retention tab on the side opposite the power supply, then press on the tab, away from the heat sink until the heat sink pops up slightly. c Rotate the heat sink back, then slide it forward from beneath the second retention tab and lift it out of the retention base. d Remove the remaining retention module clip, as needed. NOTE: Removal of the remaining retention module clip is not necessary for removal of the processor. retention module clips Removing and Installing Parts 115