Dell XPS 8910 Service Manual - Page 90
Prerequisites, Procedure, Removing the jumper plug
View all Dell XPS 8910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Prerequisites 1. Remove the right side-cover. 2. Follow the procedure from step 1 to step 3 in "Removing the power-supply unit". Procedure 1. Locate the password reset jumper (PSWD) on the system board. NOTE: For more information on the location of the password reset jumper, see "System-board components". 2. Remove the jumper plug from the password jumper-pins. Figure 42. Removing the jumper plug a. jumper plug 3. Power on without the jumper plug to clear the password. 4. Wait until the desktop is loaded and then shut down the system and replace the jumper plug in its original location. 90 System setup
Prerequisites
1.
Remove the
right side-cover
.
2.
Follow the procedure from step 1 to step 3 in “
Removing the power-supply unit
”.
Procedure
1.
Locate the password reset jumper (PSWD) on the system board.
NOTE:
For more information on the location of the password reset jumper, see “
System-board components
”.
2.
Remove the jumper plug from the password jumper-pins.
Figure 42. Removing the jumper plug
a.
jumper plug
3.
Power on without the jumper plug to clear the password.
4.
Wait until the desktop is loaded and then shut down the system and replace the jumper plug in its original location.
90
System setup