Dell mini 10v Inspiron 1011 Service Manual - Page 15

Back to Contents Page Display Dell™ Inspiron™ 1011 Service Manual Display Assembly Display Bezel Display Panel Display Panel Cable WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface. CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty. CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the computer. Display Assembly Removing the Display Assembly 1. Follow the instructions in Before You Begin. 2. Remove the battery (see Removing the Battery). 3. Remove the keyboard (see Removing the Keyboard). 4. Remove the palm rest (see Removing the Palm Rest). 5. Remove the hard drive (see Removing the Hard Drive). 6. Remove the palm rest bracket (see Removing the Palm Rest Bracket). 7. Remove the USB and SIM card board (see Removing the USB and SIM Card Board). 8. Remove the AC adapter connector (see Removing the AC Adapter Connector). 9. Remove the system board without removing the memory module and coin-cell battery (see Removing the System Board). 10. Make note of the Mini-Card cable routing and pull the Mini-Card cables out of the computer base. 11. Remove the two screws that secure the display assembly to the computer base. 1 display assembly 2 screws (2) 12. Lift and remove the display assembly from the computer base.