Denon AVP-A1HDCI Literature/Product Sheet - Page 12

Ease-of-Use Control Link allowing POA-A1HDCI settings to be made via the AVP-A1HDCI remote control unit (includes Control Link Cable: 10 ft) With the POA-A1HDCI, it is possible to switch among XLR, RCA, and OFF for the input signals and among Bi-Amp, NORMAL, and BRIDGE for the types of output, for each channel. The POA-A1HDCI is also equipped with Control Link to enable communication with the AVP-A1HDCI. When connected with a Control Link Cable, these settings can be made using the remote control unit that comes with the AVP-A1HDCI. (When the POA-A1HDCI is used on its own, switches on the rear panel is used to change the settings.) VU meters available of any channel Other Features RCA and XLR input for each channel Bi-Amp / Bridge mode select Bridged or bi-amp connections are possible by setting a switch on the rear panel that will enable the connection of a 2-channel unit to a single-channel input. Settings are made individually for each channel so that the front and centre channels can be bridged and the surround and back surround channels can be used singly. During linked control from the AVP-A1HDCI, the connection method can be selected from the AVP-A1HDCI's remote controller. Gold plated wide pitch speaker terminal Trigger input RS-232C Input / Output terminals IN OUT Others XLR EXT. RCA Speaker A L/R out Speaker B L/R out Trigger +12 V, 250 mA RS-232C Control link 10 10 10 10 1 1 IN 1 / OUT 1 Specifications Power Amplifier Section Rated output General Power supply Dimensions (W x H x D) Weight 150 W (8 ohms) 300 W (4 ohms) 300 W (8 ohms) Bridge Connection 500 W (4 ohms) Bridge Connection AC 120 V, 60 Hz 17-3/32" x 11-1/16" x 20-55/64" 434 x 281 x 530 mm 132 lbs 4 oz, 60kg *Design and specifications are subject to change without notice. *THX is a trademark of THX Ltd. THX may be registered in some jurisdiction. All rights reserved. 22 23