Denon AVP-A1HDCI Owners Manual - English - Page 14

GUI Menu Map Setup Playback Information Troubleshooting Symbols used to indicate buttons in this manual Button located on both the main unit and the remote control unit Button only on the main unit Button only on the remote control unit BUTTON [BUTTON] ENTER iPod® Playback The music on an iPod can be played by using the Control Dock for iPod (ASD-1R or ASD-11R, sold separately). The operation can also be performed using the buttons on the main unit or remote control unit while watching the GUI menus. iPod is a trademark of Apple Inc., registered in the U.S. and other countries. b The iPod may only be used to copy or play contents that are not copyrighted or contents for which copying or playback is legally permitted for your private use as an individual. Be sure to comply with applicable copyright legislation. Basic Operation uiop [ AMP] 1 Make the necessary preparations. q Set the iPod in the DENON Control Dock for iPod. (vSee the Control Dock for iPod's operating instructions.) w Assign the Control Dock for iPod's input. : "Source Select" - "(input source)" - "Assign" - "iPod dock" [ iPod] [8],[9], [6],[7], [1],[2] [POWER OFF] ENTER uiop 2 Either turn or press [iPod] (AMP mode) to select the input source assigned in step 1-w above. - GUI screen - Music Playlists Artists Albums Songs Genres Composers [1/6] iPod Music Videos [1/2] [iPod] (AMP mode) [SEARCH] [CHANNEL + -] (When using an ASD-1R) (When using an ASD-11R) b When using the ASD-11R, "Music" and "Videos" folders appear in the Top menu. b When communication between AVP-A1HDCI / AVR-5308CI and iPod is complete, the relevant GUI screen is displayed. If the screen is not displayed, the iPod may not be properly connected. Try connecting again. (Main remote control unit) [2] [8] [REPEAT] [SEARCH] [9] [1/3] [RANDOM] : "Source Select" - "(input source)" - "Play" (vpage 6) 3 To operate using the main remote control unit, set the remote control unit to the iPod mode. 4 Press [SEARCH] and hold it down for a 2 seconds or more to select the display mode. To switch between modes, press and hold down the button. When remote mode is active, "Remote" is displayed. [Display mode] Browse mode Remote mode Display location Main unit display iPod display Playable files Active buttons Audio file Video file Remote control unit (AVP-A1HDCI / AVR-5308CI) iPod S S z1 S A S Sz2 S S z1 : When using an ASD-11R control dock for iPod. z2 : Video may not be output, depending on the combination of ASD-1R and iPod. • With the default settings, the iPod can be used connected to the VCR (iPod) connector. • Use the RESTORER mode to expand the low and high frequency components of compressed audio files and achieve a richer sound. The default setting is "Mode3". • Press or [POWER OFF] and set the AVP-A1HDCI / AVR-5308CI's power to the standby mode before disconnecting the iPod. Also switch the input source to one to which the GUI menu "iPod dock" is not assigned before disconnecting the iPod. NOTE • Depending on the type of iPod and the software version, some functions may not operate. • DENON will accept no responsibility whatsoever for any loss of iPod data. Listening to Music 1 Use ui to select the search item or folder, then press ENTER or p. b When using the ASD-11R, select "Music" on the Top menu. 2 Use ui to select the music file, then press ENTER or p. Playback starts. 14 (Sub remote control unit)