Denon AVR 4308CI Owners Manual - English - Page 19

GUI Menu Map Setup Playback Information Troubleshooting Symbols used to indicate buttons in this manual Button located on both the main unit and the remote control unit Button only on the main unit Button only on the remote control unit BUTTON [BUTTON] QUICK SELECT QUICK SELECT Operations 1 Connect the HDMI to the AVR-4308CI / AVR-3808CI with equipment compatible with the HDMI control function. 2 Put the power on for all the equipment connected to the HDMI. 3 Check the settings for all the equipment connected to the HDMI and make HDMI available to them. b Please consult the operating instructions for the connected equipment to check the settings. b Steps 1~3 do not have to be repeated once started. b Carryout steps 2 and 3 should any of the equipment be plugged out. 4 Switch the television input to the HDMI connected to the AVR-4308CI / AVR-3808CI. 5 Switch the AVR-4308CI / AVR-3808CI input to the HDMI input source and check if the picture from the player is ok. ENGLISH • If the AVR-4308 / AVR-3808 does not work please check the following. • Is the GUI menu "Manual Setup" - "HDMI Setup" - "HDMI Control" - "Control" (vpage 4) set to "ON"? • Is the GUI menu "Manual Setup" - "HDMI Setup" - "HDMI Control" - "Control Monitor" (vpage 4) set for the monitor output connected to television? (AVR-4308 only) • Is the GUI menu "Manual Setup" - "HDMI Setup" - "HDMI Control" - "Power Off Control" (vpage 4) set to "ON"? • Is the control function used for the television HDMI properly set? (Check the television operating instructions for details.) • Should any of the operations below be performed, the interlocking function may be reset, in which case, repeat step's 2 and 3. • GUI menu "Source Select" - "(input source)" - "Assign" - "HDMI" (vpage 5) setting has changed. • There is a change to the connection between the equipment and the HDMI, or an increase in equipment. • Whennot using this unit for a long period, we recommend that you press to turn off (jOFF) the power. When "Control" (vpage 4) is set to "ON", it consumes more standby power. When you start to use the unit again, redo the settings in steps 2 ~ 6. 6 Put the television power on standby and check if the AVR-4308CI / AVR-3808CI goes into standby. Quick Select Function With this function, the currently playing input source, input mode, surround mode, room EQ, Dynamic EQ, Dynamic Volume settings and volume can be stored in the memory. 1 Set the input source, input mode, surround mode, room EQ, Dynamic EQ, Dynamic Volume settings and volume to the conditions you want to store. 2 Press and hold the desired QUICK SELECT. Keep pressing the button until the quick select indicator lights. [Quick Select Defaults] Quick Select 1 Quick Select 2 Quick Select 3 Input Source DVD TV/CBL VCR Volume -40 dB -40 dB -40 dB 18